Release Notes

Product:		ENTTEC OCTO MK2
Product SKU: 	71521
------------------------------------------------------------------------------------------------------------
Note: Please check product serial number to load the compatible firmware versions:
OCTO MK2 - SN up to 2323030 - V2.1 Only
OCTO MK2 - SN 2341008 to 2350677 - V3.0-V3.1 Only
OCTO MK2 - SN 2374307 onwards - V4.0 onwards

------------------------------------------------------------------------------------------------------------
V4.2 Sept 2023
-Increased Universe capacity with Overdrive Mode, enabling 8U per output (total 16U):
	-The unit will still default to 4U per port
	-When setting at higher universe output will reduce max framerate, max framerate possible in each overdrive universe is listed in a tooltip.
-Reintroduction of Standalone mode:
	-Standalone now supports 16bit protocols and 8U per port
	-Able to have between 1 and 15 unique colour markers
-Universe buffer added to each port with Auto refresh.
	-Can view 2 universes simultaneously (1 per port) 
Bug fixes:
-HTTP responses now use HTTP V1.1 (rather than 0.9)
-fix for 16bit protocols when colour order is set to RGBW

Note: It is strongly recommended to factory reset from the RESET BUTTON for a smooth firmware update before updating to V4.2
In the case of updating to V4.2 and the unit doesn't reboot successfully, follow the factory reset guide below will boot the device to V4.2
Factory Reset by Reset Button:
- Power down device.
- Hold reset button down.
- Power device with reset button held down.
- Keep reset button held down until the LED starts blinking red. 
- Release the reset button.  
- Power cycle the unit.  

----
V4.1 May 2023 
- Fixed ArtPoll response for every universe.
- Fixed APA102 and TM1814 mapped pixels.

----
V4.0 Sep 2022 										
- Initial release for GD32.
- Removed Standalone feature in front end.
- Added custom timing/protocol feature
- Allowed different portocol in each port
- Allowed both RJ45 Port to be used without rebooting
- Updated Help Page LED indicator
- Fixed bugs from V3.1
	- WWA colour orders
	- Pixel grouping update from mapped pixel display settings
	- Cyan LED indicator for merge error
	- Fall back IP 192.168.0.10 when DHCP enabled but not working

----------------------------------------------------------------------------------------------------------------
V3.1 Sep 2022 										
- Added SACN Multicast implemention
- Fixed UCS2904 bug.

Note: It is strongly recommended to factory reset from the RESET BUTTON for a smooth firmware update before updating from V3.0 to V3.1.
In the case of updating from V3.0 to V3.1 and the unit doesn't reboot successfully, follow the factory reset guide below will boot the device to V3.1.
Factory Reset by Reset Button:
- Power down device.
- Hold reset button down.
- Power device with reset button held down.
- Keep reset button held down until the LED starts blinking red. 
- Release the reset button.  
- Power cycle the unit.  

----
V3.0 Jan 2022 		
- Initial release 
- Removed Standalone-Background settings (Dim, Strobe, Frequency etc).

-----------------------------------------------------------------------------------------------------------------
V2.1 Feb 2021 										
- Initial release
Note: Octo and Octo MK2 firmware mutually exclusive, please pick the correct version for matching Octo revision